A/d/s/ plate amp has so many inputs!!
Posted: Thu May 28, 2009 10:48 am
Ok for those of you have seen an a/d/s/ amp you know that the wiring harness for the inputs has something like 3 input rca's My Alpine currently has three 2 volt outputs... How would i drive both my a/d/s/s amp and my autotek amp if this requires 4 outputs?
I' was thinking of some how splitting off one of the wires to the a/d/s/ amp so that one of the outputs ran 2 sets going to the a/d/s amp and run one of the sets that would be my 3rd channel to the sub output.
The Autotek would get its own output so here is a little chart to explain what i mean...
Channel 1/2 would be bridged for 88w Channel 3/4 same deal and Channel 5/5 same...
1/2 & 3/4 would be left and right comp and 5/6 would run a small dayton 8" woofer in a sealed box.
Let me know what thoughts you have.
I' was thinking of some how splitting off one of the wires to the a/d/s/ amp so that one of the outputs ran 2 sets going to the a/d/s amp and run one of the sets that would be my 3rd channel to the sub output.
The Autotek would get its own output so here is a little chart to explain what i mean...
Channel 1/2 would be bridged for 88w Channel 3/4 same deal and Channel 5/5 same...
1/2 & 3/4 would be left and right comp and 5/6 would run a small dayton 8" woofer in a sealed box.
Let me know what thoughts you have.