Page 1 of 1
My remote wire on my pioneer DEH 8600MP pulled out while removing it from my car
Posted: Sat Feb 28, 2009 1:09 pm
by Mithrandir
It came out of the harness that connects to the deck, if i by chance cant get a new harness from the factory what can I do to fix this or by pass it so my amps or whoever buys my decks, amps still turn on? Or do you think i can find a diagram of the harness and solder it back inside?
Posted: Sat Feb 28, 2009 2:19 pm
by Ryan from Ohio
Well did the wire just break off or did it pull the entire "pin" out of the plug?
Posted: Sat Feb 28, 2009 2:57 pm
by MobileAudio219
Does it have a power antenna wire???
Posted: Sat Feb 28, 2009 3:05 pm
by MobileAudio219
If it just pulled the "pin" out of the harness, drop it back through. If the wire pulled off the pin, pull the pin out, solder a new piece of wire on, and drop the pin back through.
If the pin/wire both are gone, wire it to the ignition wire? I can't remember if the power antenna wire gets hot with the deck, or when you switch the am/fm on... Might be able to just use that?
Posted: Sat Feb 28, 2009 10:33 pm
by loudwagon15s
you might get lucky, yesterday i went to circuit city, and they had all of their audio accessories out, i found a pin to go into a jvc unit, exactly what i needed. If one is a around, and still open its worth checking out
Posted: Sun Mar 01, 2009 9:49 am
by Mithrandir
MobileAudio219 wrote:If it just pulled the "pin" out of the harness, drop it back through. If the wire pulled off the pin, pull the pin out, solder a new piece of wire on, and drop the pin back through.
If the pin/wire both are gone, wire it to the ignition wire? I can't remember if the power antenna wire gets hot with the deck, or when you switch the am/fm on... Might be able to just use that?
I believe it pulled the pin out of the harness, but i have 2 problems. I dont know what empty slot it goes into and It doesnt fit correctly into the harness, ill take a picture and post it.