Page 6 of 6
Posted: Wed Dec 12, 2007 10:37 pm
by JeremyC
Ok first what is the RMS of those subs. I'm guessing 2000 watts is a peak rating.
Second, it sounds like you have your speakers wired for an ohm load the amp doesn't like. Thats why its cutting out.
Posted: Thu Dec 13, 2007 5:34 am
by Bwcad1
cblaze wrote:same board dont matter,its the stuff on it that does
including components. running an amp at .35 is stupid its risking equipment and lessening the length of life of that amp.
Posted: Fri Dec 14, 2007 3:34 pm
by cheapaudio
yea i figured it out i had them both wired to 4 ohms each , one to each channel but had the amp on LP which the amp will only do with mono off. so i just took one 12 to 4 ohms and bridged it.. sounds alot better..