amp opinions

JeremyC · Post by **JeremyC** » Wed Dec 12, 2007 10:37 pm

Ok first what is the RMS of those subs. I'm guessing 2000 watts is a peak rating.

Second, it sounds like you have your speakers wired for an ohm load the amp doesn't like. Thats why its cutting out.

Bwcad1 · Post by **Bwcad1** » Thu Dec 13, 2007 5:34 am

cblaze wrote:same board dont matter,its the stuff on it that does

including components. running an amp at .35 is stupid its risking equipment and lessening the length of life of that amp.

cheapaudio · Post by **cheapaudio** » Fri Dec 14, 2007 3:34 pm

yea i figured it out i had them both wired to 4 ohms each , one to each channel but had the amp on LP which the amp will only do with mono off. so i just took one 12 to 4 ohms and bridged it.. sounds alot better..