Posted: Fri Dec 01, 2006 3:08 pm
Awesome :happy055:Ryan from Ohio wrote:I got the studs out of that spindle...
PITA
WIll be dropping it off tomorrow around non-early afternoon!
Thanks again Ryan
Thanks again Ryan
Car Audio Central - Ultimate Car Audio Forum and Community
A Car Audio Forum dedicated to providing our members with the best audio, video, and alarm troubleshooting.
https://caraudiocentral.net/forums/
Bill's extended Build Update
Page 5 of 9
Thanks again Ryan
Posted: Sat Dec 02, 2006 8:22 am
Looking like 2:30ish...
Watching a movie @ Franklin Park then will be out.
I pulled all 5 studs out. Just incase the other was cracked.
3 were fresh cracked, that one was broke for some time Mike. I would check them all for other possible breaks/cracks.
I got them out with a small butane soldering torch, vise and a BFH Big F'in hammer... WOuldnt fit in the press properly.
Watching a movie @ Franklin Park then will be out.
I pulled all 5 studs out. Just incase the other was cracked.
3 were fresh cracked, that one was broke for some time Mike. I would check them all for other possible breaks/cracks.
I got them out with a small butane soldering torch, vise and a BFH Big F'in hammer... WOuldnt fit in the press properly.
Posted: Sat Dec 02, 2006 1:23 pm
So hows the fiesta going?
Posted: Sat Dec 02, 2006 6:04 pm
We got the alt hooked up... more glass work continuing right now... and the back wheels are back on :)
The down side is that the motor doesn't want to start
I think it's a problem with the teeth on the starter or actuator in it... starts to turn over but stops.
So I got some more work ahead of me under the car now.
Hey Joe... How bout some Pizza... Bill said give him a call too.
The down side is that the motor doesn't want to start
I think it's a problem with the teeth on the starter or actuator in it... starts to turn over but stops.So I got some more work ahead of me under the car now.
Hey Joe... How bout some Pizza... Bill said give him a call too.
Posted: Sat Dec 02, 2006 10:26 pm
Pizza made it out, Jay(Pornstar) delivered it.
Posted: Sun Dec 03, 2006 5:51 am
Yup sure did :happy055: Thanks JOE!OnYrMrk wrote:Pizza made it out, Jay(Pornstar) delivered it.
Jay came back after work at around 2:30-3ish AM and he and Dusty stayed till who knows when... but they got the port walls up and the wires run to the subs and subs in... so we're ready to start testing :)
Posted: Sun Dec 03, 2006 7:36 am
Explain the starter deal to me
Does it just stop completely or slow down?
Does it just stop completely or slow down?
Posted: Sun Dec 03, 2006 9:18 am
When I was there it wouldnt even turn over.
It would engage but fall right back off.
Last I heard, Mike was going to try turning the engine over @ the crank to see if it would even turn over that way. Guess the cars been sitting unused for about a year.... So the motor, well it might of rusted up/frooze up...
It would engage but fall right back off.
Last I heard, Mike was going to try turning the engine over @ the crank to see if it would even turn over that way. Guess the cars been sitting unused for about a year.... So the motor, well it might of rusted up/frooze up...
Posted: Sun Dec 03, 2006 3:40 pm
i think its froze but thats just meed probably an engine swap in the future. o yea and by the way 150 @ 29hz
Posted: Sun Dec 03, 2006 4:34 pm
29 hz? damn dude....thats damn near the brown note at that volume aint it? are you gonna tune higher to try to get louder?