Page 2 of 2
Posted: Mon May 14, 2007 6:46 pm
by colemanyoungerinalaska
use a relay i got that. next question what needs to be done to make a 4ohm amp stable at 2 ohm im pretty good with electronics and built amps when i was younger i cant remember all the theory but could definitely do whatever needs to be done im good with a soldering gun i dont need this i just think it would be fun to do
Posted: Mon May 14, 2007 7:10 pm
by Bwcad1
alot of modifications. measure the DCR of the sub coils chances are your amp will be ok at 2 ohm because of impedance rise.
Posted: Tue May 15, 2007 5:20 am
by CaptainPioneer
Best Heat Sinc i ever used was the TermalTake Big Typhoon... it kinda looks like an Engine hovering above the Chip... Its big ... almost didnt clear my case but it is awesome!
Posted: Wed May 16, 2007 5:19 am
by GlassWolf
class AB amps always run hot.
if you need a mono 2 ohm amp, go buy a class D amplifier. it'll run cooler, and it's made for what you're doing.
it'd cost more to rebuild the amp for lower loads than it'd cost to buy a new amp.
Posted: Wed May 16, 2007 9:56 pm
by colemanyoungerinalaska
i like to overclock computers alot and i thought i could cheaply overclock and amp but from what ive read the answer is no. i think full immersion cooling would look really cool and i may do something with that this summer.