Page 2 of 3
Posted: Wed Jun 28, 2006 10:31 am
by OnYrMrk
yea, Dane is quite the funny guy. I listen to Larry the Cable guy whenever I can
Posted: Wed Jun 28, 2006 10:57 am
by CaptainPioneer
George Carlin is Hillarious as well. I love his comedy.
Posted: Wed Jun 28, 2006 12:44 pm
by the dawg
Getting back to the original post , settings on bx1000d, Anybody else have any ideas on these settings??
Posted: Wed Jun 28, 2006 2:35 pm
by the dawg
Anybody have any ideas on these settings? Again, my hifonics bx1000d has subsonic filter, lowpass, bass boost, phase 0-180, voltage settings.
Posted: Wed Jun 28, 2006 6:44 pm
by Bwcad1
um i guess you didnt like my proposition? i told you if you wanted to stop by i could check it out for you
Posted: Thu Jun 29, 2006 4:06 am
by the dawg
Yea man, that'd be cool. Where in ohio are you located at ?
Posted: Thu Jun 29, 2006 4:07 am
by Bwcad1
medina.
Posted: Sat Jul 01, 2006 4:29 pm
by the dawg
Hooked up the bx1000d and the sub does not hit that hard. The settings on the amp are: Lowpass about 80; Subsonic at 0; Bass Boost at 0; Phase at 0; Gain(Voltage)little over halfway-about 4 volts. This is in my '97 Grand Cherokee , the sub is in a small sealed box sitting over the right wheelwell firing towards the other wheelwell(side firing). Any ideas on settings or sub placement that would make the sub hit harder and tighter???
Posted: Sun Jul 02, 2006 4:39 am
by the dawg
Maybe a bigger box?? It is in a small sealed box about 1.0 cubes, is this big enough for a 12" type-r ??
Posted: Sun Jul 02, 2006 5:45 pm
by the dawg
I might try building a ported box as I hear type-r's do better ported vs. sealed. However I have never built a ported box before. Any ideas where I can find some plans to build such a box??