Page 2 of 2
Posted: Fri Oct 28, 2005 11:39 am
by sinister audio
why i like to tune low for certain subs is 1 to get a flat response on my plotting software and it will play all the freq you would ever want at a decent output. ill throw those specs into my program and figure out a decent box for you.
Posted: Fri Oct 28, 2005 11:46 am
by Darthness
ok. would be extremely appreciateive if you wold
Posted: Fri Oct 28, 2005 2:07 pm
by sinister audio
alright to get a flat response on my program it wants to see that sub in a 6.42 tuned to 20.6 so i dont htink you want to go that big. so i tried a 3 cube tuned to 26.08 and it does pretty nicely dosnt look to much differnt than the JL box so since your concernd with room i would go with the jl box. and if you could make it 30x15x15.5 then your tuning will be right. if that wont fit i can redo it some.
Posted: Fri Oct 28, 2005 3:34 pm
by Darthness
ok. 30 inches wide you mean? if thats the case, then yeah i could most likely fit that. but i think for the gains i'd be receivving it'd be worth it.
thanks for all your help, if we can figure everythign out, maybe nextmonth i'll actually do it.. i need to finish dynamating my trunk and figuring out what is causing one of my panels to rattle so bad.
Posted: Fri Oct 28, 2005 3:44 pm
by sinister audio
yep 30 wide. sound deadening helps quite a bit too.
Posted: Fri Oct 28, 2005 4:03 pm
by Darthness
i just got back from taco bell. the small bit of dynomat i put in helped immensly.
Posted: Sat Oct 29, 2005 9:15 am
by Darthness
is all this before port displacement? or after?
But hey, do i keep the same port tuning as JL reccomends or what? with tthe 30x15x15.5 box.
JL reccomends a 15.5" tall port, 1.5" wide. instead, could i make it 15"tall, 2.0" wide? 31" Deep with a 13.5" extention. im going to get the mdf soon, i don't have quite enough for this box. but im also going to try and get it done between today and tommorow, woot.
Posted: Sat Oct 29, 2005 11:53 am
by Darthness
effin great, i wasted $30 at home depot only to find out that i barfed the entire thing up because i can't cut straight. actually, i was going pretty good until i started chopping part of my table off. i think im just going to pay justin or someone to draw up blueprints and then pay the shop near me $150 to build it.
Posted: Sat Oct 29, 2005 4:37 pm
by sinister audio
i can give you a cut list its not too hard. i could make it for you too if you wanted
Posted: Sat Oct 29, 2005 8:44 pm
by Darthness
comming up with the cuts, unfortunently, is not my problem. im pretty sure i had it down, its just i can't cut worth shit and i don't have any shop like thigns to go with, ie.. righit now, i'm cutting off of a frickern plastic lawn table with spare mDF holding what im cutting down.