Looking for a dealer

swimmerdude · Post by **swimmerdude** » Fri Mar 16, 2007 10:22 am

look on the site mang!!! http://tcsounds.com/tc3000.htm In the wiring diagrams, those are listed as dcr ratings.... but the nominal is .5 for the .35 wiring.

loudwagon15s · Post by **loudwagon15s** » Fri Mar 16, 2007 11:00 am

x2 ^ an idiot friend of mine just blew a 1206 for, whatta ya' know? cranking the gains....stupid people annoy me

Bwcad1 · Post by **Bwcad1** » Fri Mar 16, 2007 11:14 am

as long as the gains are set correctly with the load on the woofers you should be ok. .35 is a little low though i don't know if i would recommend that. I think the best load for you to run would be .7 ull get good power from your amp and you wont have to worry about over doing it.

captaincheesey · Post by **captaincheesey** » Fri Mar 16, 2007 1:25 pm

I think I will stick with the 1606 when I get it at 2 and then eventually get another amp that will put out more.

cargodz · Post by **cargodz** » Fri Mar 16, 2007 3:35 pm

.35 is too low as Bill stated... You'll find it constantly in protect

Bwcad1 · Post by **Bwcad1** » Fri Mar 16, 2007 3:37 pm

actually mike it will run at .35 but you would have to set the gains very low and your voltage would have to stay high.

cargodz · Post by **cargodz** » Fri Mar 16, 2007 3:44 pm

I didn't say it wouldn't, but I know they start getting really finiky at that low a levels so you gotta have every lil thing just perfect... heck just the atmospheric change in the car can make the difference in the performance level... Like you said, I've seen to many kids bring them in thinkin that there was something wrong when all it was is improper gain on these.
I'm not sayin it can't be done, just sayin that they get really touchy