Fiberglass+Tweeters

solacedagony · Post by **solacedagony** » Thu Aug 10, 2006 6:04 am

Ok, I'm thinking my first delving into fiberglass is going to be to fiberglass a new surrounding plastic piece for my door handle so I can throw my tweeters on there. Would this be an OK place for a tweeter or should I keep them high. I know there's not a lot of room in my truck. The only other option I was considering was sticking them on the inside of the A-pillar and fire them across. I was also considering putting in a 3 way setup if I do it that way because I could probably squeeze the midrange and tweeter onto the inside of the A pillar firing across. I really have no clue :)
Any help guys. Thanks.

MobileAudio219 · Post by **MobileAudio219** » Thu Aug 10, 2006 6:26 am

Play with them..

It's going to change with every install, what works on one car may not work on another.

So... Get out there and experiment! :happy055:

solacedagony · Post by **solacedagony** » Thu Aug 10, 2006 8:04 am

I was planning on experimenting, but I was more referring to if placing them low in a small vehicle would cause problems. Like blocking them and whatnot.

MobileAudio219 · Post by **MobileAudio219** » Thu Aug 10, 2006 9:46 am

solacedagony wrote:I was planning on experimenting, but I was more referring to if placing them low in a small vehicle would cause problems. Like blocking them and whatnot.

Try it and see... Its kind of hard to know without seeing the truck, or atleast knowing what kind of truck it is, and where exactly are you wanting to put them... :happy055:

jmlaudio · Post by **jmlaudio** » Wed Aug 16, 2006 7:16 pm

A pillar across the dash for higher staging or in the kickpanels for more centered staging

MobileAudio219 · Post by **MobileAudio219** » Wed Aug 16, 2006 8:20 pm

jmlaudio wrote:A pillar across the dash for higher staging or in the kickpanels for more centered staging

Not necessarily...

Oh and, another missourian ftw! :happy055: