Bass causing skippage

RamZ · Post by **RamZ** » Fri Mar 11, 2005 11:20 am

I installed my hu yesterday (jvc kd-ar7000) and everything is running fine n dandy. but when i turn it up and the 2 12s get goin, the cd starts to skip. Is there something i can do to stop this or does the hu not have good skip protection?

Scarrell · Post by **Scarrell** » Fri Mar 11, 2005 11:28 am

your cd player is not installed securily is the problem.. try tightning it or adding some sort of padding or something. but the problem is Probably it not being secure in its place.

dmeyer07 · Post by **dmeyer07** » Fri Mar 11, 2005 11:34 am

Well first off, as I’m sure you are aware the HU that you installed doesn't have all that great of skip protection, in fact it has no Pre-Skip memory (Reads ahead a # of seconds to prevent skipping during most driving conditions).

Also as stated above make sure your HU is installed securely, and try placing a strip of rubber around the mounting area to mount the HU onto. This should help eliminate your skipping problem.

dmeyer07 · Post by **dmeyer07** » Fri Mar 11, 2005 11:43 am

Nice looking Hu.

RamZ · Post by **RamZ** » Fri Mar 11, 2005 11:53 am

my stock cd player was like a DIN and a half so i had to get a kit. So it is kinda free floating in there. Ill try placing some rubber or something inside.

dmeyer07 · Post by **dmeyer07** » Fri Mar 11, 2005 11:55 am

Well placing rubber inside isn't going to do much, its where the actual HU or in your case kit is mounted to the veichle.You want something there that can absorbed the vibrations cause by the subwoofers.

RamZ · Post by **RamZ** » Fri Mar 11, 2005 11:58 am

Like What?

RamZ · Post by **RamZ** » Fri Mar 11, 2005 11:59 am

And thanx for all the advice!

dmeyer07 · Post by **dmeyer07** » Fri Mar 11, 2005 12:09 pm

Well I'd just keep it simple and get a strip of rubber to place in between the kit and the vehicle. But something along the lines of a foam gasket, i.e. speaker baffle type material, etc would work.

Also if you are having problems with your rear view mirror vibrating, license plate, etc... The same thing can be done by simply placing rubber between the license plates, and the car.

Just play around a bit and find something that works, but for me rubber was the key.

Hope this helps.

Dave

Ryan from Ohio · Post by **Ryan from Ohio** » Fri Mar 11, 2005 12:25 pm

What kind of vehicle?

I have a 97 Century and I couldnt get the radio to lock into its sleeve...

I ended up using the trim ring with the fit kit to achieve the look of mine.

Pics are in the Product Review section