is this a good idea

syang · Post by **syang** » Sat Aug 13, 2005 9:42 pm

like i said before i have got my lanzar amp it's working pretty well i like it...right now i have my infinity refences 10" sub 1000w peak and 250 rms being bridge on the lanzar 421 amp... i was wondering if i could hook up 2 of the RE subs in the same channel... so in all there is three subs being powered by half of the amp. cause the amp is a four channel amp... sorry if i'm confusing you

William from NOLA · Post by **William from NOLA** » Sat Aug 13, 2005 10:31 pm

What are the voice coil configurations to each of the subs and what ohms are each? What is the amp's rated power?

syang · Post by **syang** » Sun Aug 14, 2005 7:53 am

all the subs are 4 ohms and the amp is 1000 max, 250 max per channel and 125 rms..

William from NOLA · Post by **William from NOLA** » Sun Aug 14, 2005 9:31 am

Are any of the subs dual voice coil? and Is that 125 rms at 4 or 2 ohms?

syang · Post by **syang** » Sun Aug 14, 2005 9:36 pm

the 125 rms is at 4 ohms

William from NOLA · Post by **William from NOLA** » Sun Aug 14, 2005 10:00 pm

Well, you could (assuming each sub is a single voice coil), put the two RE's on either the left or right channel and use the Infinity on the opposite. Or if you wanted to use all 4 channels, bridge the front set of outputs and put the Infinity on those, then put each RE on an individual channel on the rears.

smoker · Post by **smoker** » Mon Aug 15, 2005 5:00 am

im that amp is stable under 4 ohms on the bridged output you could series wire the two re subs together for 8 ohms, then parallel wire the infinity and the re setup and this would give you 2.66 ohms....