Car Audio Central - Ultimate Car Audio Forum and Community

900 watts would need a fuse around 80-90A to handle the current draw without blowing. the amp clipping was what burned up the one sub though. that was due to the mis-wiring and trying to run at half an ohm. 2 ohms is ideal anyway with that amp. 450 watts per sub, which is already 50 watts over the ...

how many watts RMS does each amplifier you have put out as they're wired up now? Answer that and I can tell ya what size fuses ya need. as for gain, those numbers are voltages, to match to your head unit's pre-out voltage. if the head unit is 2 volts, you set the amp gain to "2" and if it...

Well sh*t... Turned out I had the subs running in 0.5 Ohm on my 1 ohm stable amp... thats why the fuses were popping like a new hooker.. So I wired the subs back up in series to gain a 2ohm load, sucess... listened to one of the subs with my ear right up to it and it sounded a bit distorted.. hmm, k...

So i've unhooked the ground that was from the amp, to cap, to chassis. and put it to the same chassis ground, just on its own wire.. the cap has its own wire aswell, im using all 4 gauge... Did that this morning before work and I can say that it deffinately helped out alot! I can play out loud musi...

So i've unhooked the ground that was from the amp, to cap, to chassis. and put it to the same chassis ground, just on its own wire.. the cap has its own wire aswell, im using all 4 gauge... Did that this morning before work and I can say that it deffinately helped out alot! I can play out loud music...

No Its not resolved.. Im not sure how that got on the title of my post... Im just adding comments as i think of them... YES the Kenwood amp KAC-9152D is 1ohm stable, 900 watt RMS

Oh yea!. I have the subs running in Parallel... And im not TOTALLY sure, but i was running dual 4 ohm subs in parallel the other day and i was reading 1 OHM?! on my meter... So i got these hooked up the same way and they are also reading 1ohm?!.. anyway.. i want 1 ohm cuz the amp supports it, not FU...

Also!... The car will only act up at certain times in the day, no matter how to tell when its going to act up.. But when it does, all it wants to do is turn off likes it not getting enough power.... I push in the brakes, Boom, it stalls... I try to use heater, boom stalls.. Just put in a new 105 Amp...

THE amp will shut off for a period of 1 second to 5 seconds.... THen turn right back on and start playing again... But if i havent turned the volume down by the time it turns back on it'll go right back off again...!

Hello all! Need a bit of help with my setup, I have a Kenwood KAC-9152D Mono block amp pushing 2xKicker CompVR's dual 2ohms... I've got 2 gauge wire from the amp to battery, and a ground wire close to the amp.... I have also just put in a new capacitor (which i think was a mistake), that is also tie...