Car Audio Central - Ultimate Car Audio Forum and Community

Oh yea another question...

If the an amp is 300x1 @ 4 ohms and 600x1 @ 2 ohms, then it would be correct to say that its 450x1 @ 3 ohms - right?

I'm assuming its split right down the middle?

In a two channel amp, NEVER go lower than the rated bridged ohms. This will cause the amp to overheat and be very unstable. You will probably be better off with a monoblock amp or buy another w6 and search for a 1 ohm amp. I only say the above to be safe. It's never bad to be too careful, especiall...

Hey guys - I need a new amp for my JL 12W6 and I was wondering if the Orion 6002 is good a match...I can get a brand new one for about $195 shipped...

What concerns me is that the lowest impedence is 4 ohms in bridged mode and the 12W6 is a 3 ohm sub....

Will that be a problem?

Thanks in advance!!