by smoker » Sun Sep 11, 2005 6:21 am
Rated Power (mono): 120 W RMS x 1 @ 4 ohm (12.5V); 200 W RMS x 1 @ 2 ohm (12.5V)
THD at Rated Power: <0.08% @ 4 ohm (20 Hz -20 kHz)
S/N Ratio: >104 dB referred to rated power (A-weighted, 20 Hz – 20 kHz noise bandwidth)
Frequency Response: 10 Hz – 25 kHz (+0, -1dB)
Damping Factor: >200 @ 4 ohm / 50 Hz, >100 @ 2 ohm / 50 Hz
not a very good sub amp...low power and not so good damping factor makes for so so performance. if it were me and i was going to run that amp, keeping in mind that the power rating is at 12.5 volts, i would consider a pair of comp 10's and the reason being you have enough power to decently drive them and you will see an increase in spl due to the second sub. mount them close together in a sealed box and i think you will be happy with what you wind up with.
arguments to follow
Rated Power (mono): 120 W RMS x 1 @ 4 ohm (12.5V); 200 W RMS x 1 @ 2 ohm (12.5V)
THD at Rated Power: <0.08% @ 4 ohm (20 Hz -20 kHz)
S/N Ratio: >104 dB referred to rated power (A-weighted, 20 Hz – 20 kHz noise bandwidth)
Frequency Response: 10 Hz – 25 kHz (+0, -1dB)
Damping Factor: >200 @ 4 ohm / 50 Hz, >100 @ 2 ohm / 50 Hz
not a very good sub amp...low power and not so good damping factor makes for so so performance. if it were me and i was going to run that amp, keeping in mind that the power rating is at 12.5 volts, i would consider a pair of comp 10's and the reason being you have enough power to decently drive them and you will see an increase in spl due to the second sub. mount them close together in a sealed box and i think you will be happy with what you wind up with.
arguments to follow