Attention all members!
Have a cool ride? Then show it off on our website! All vehicles welcome!

How to bridge 4 ch amp to run just the fronts?

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:awesome: :argh :ditto :inout :words :bow :cheers: :bigwink: :fing02: :sad017: :scorp: :o :D ;) :p :unwell028 :tongue017 :thumbsup :surprised :sm29: :angry011: :angry015: :angry012: :nono: :angry010: :nono :banghead :mad: :dif :angry :CRZ_13: :eek: :confused: :confused0 :confused :( :sad: :cool: :dance :mecry: :jesterlol :embarrass :flame: :doh :evil019: :evil001: :rolleyes: :sub:
View more smilies
BBCode is ON
[img] is ON
[url] is ON
Smilies are ON
Topic review
   

Expand view Topic review: How to bridge 4 ch amp to run just the fronts?

by neonblack » Wed Jun 08, 2011 5:43 pm

Look at the manual - they usually show you how to bridge 4 channels into 2 channels. If you don't have a manual look around the internet and usually can find one for free. I did that with an older Kenwood 4-channel and it kicked ass at 150W RMS x 2.

by NorthQuad » Sun Mar 27, 2011 5:21 pm

Just wire your components with 75 rms per side. You don't need to be smokin your tweets.

How to bridge 4 ch amp to run just the fronts?

by jjohan35 » Fri Feb 11, 2011 6:19 pm

Hi everyone,

I have a 75x4 amp, bridged 225x2. If I want to bridge the channels to supply 225 rms to each side of my component system, how would I go about doing this? My head unit has 3 pairs of RCA outputs: 1 front, 1 rear, 1 sub. I know how to bridge my amp for mono output, but I'm not entirely sure how to separate the right and left RCAs so that one bridge supplies the left component half while the other bridge supplies the right component half. Am I making any sense?

Top