by htownplaya456 » Wed Mar 07, 2007 5:01 pm
I have the arc audio 2500-xxk and it says not to operate less than 4 ohms bridged but I have a question... has anybody worked with this amp alot and into detail to know if it could handle a lower load when bridged... I would think it would because its a high quality amp but they advise not to... I know that if on most A/B class amps that it can mess up the amp if wired lower than 4 ohms unless its made to be stable at 1 ohm or whatever. But what I need out of it is a about a 20 second burp at 1 ohm. If I can't do this then I might find a different amp or something.
I have the arc audio 2500-xxk and it says not to operate less than 4 ohms bridged but I have a question... has anybody worked with this amp alot and into detail to know if it could handle a lower load when bridged... I would think it would because its a high quality amp but they advise not to... I know that if on most A/B class amps that it can mess up the amp if wired lower than 4 ohms unless its made to be stable at 1 ohm or whatever. But what I need out of it is a about a 20 second burp at 1 ohm. If I can't do this then I might find a different amp or something.