Attention all members!
Have a cool ride? Then show it off on our website! All vehicles welcome!

Bass control knob + head unit control

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:awesome: :argh :ditto :inout :words :bow :cheers: :bigwink: :fing02: :sad017: :scorp: :o :D ;) :p :unwell028 :tongue017 :thumbsup :surprised :sm29: :angry011: :angry015: :angry012: :nono: :angry010: :nono :banghead :mad: :dif :angry :CRZ_13: :eek: :confused: :confused0 :confused :( :sad: :cool: :dance :mecry: :jesterlol :embarrass :flame: :doh :evil019: :evil001: :rolleyes: :sub:
View more smilies
BBCode is ON
[img] is ON
[url] is ON
Smilies are ON
Topic review
   

Expand view Topic review: Bass control knob + head unit control

by NViejeP » Wed May 03, 2006 6:58 pm

Haha! Hooked up my friends JL 12w6.. sounded great. Perfect.. I hope the RE SE is almost as good if not as good.

by JL Man » Wed May 03, 2006 4:32 pm

my 500/1 has that jl rbc-1 bass knob. they said its a bass boost knob. so if i turn that up because someone next to me trying to show me up it wont hurt anything huh, just give me a lil extra boom

by NViejeP » Wed May 03, 2006 3:40 pm

Oh I see. Hum.. I might need some help setting my xover and gains adn stuff when I install my sub..

by lotas » Wed May 03, 2006 2:29 pm

Justin brought up the remote gain being a different story because there are remote gain knobs, and remote bass-boost knobs. The misconception is some people think they are just turning up the bass-boost when really they are cranking the gain. This can result in clipping the amplifier, damage to the drivers, etc, so you have to be careful.

by JeremyC » Wed May 03, 2006 1:24 pm

gain = Set to adjust the input stage on the amp to the output stage on the headunit. So the higher the output voltage on the deck, the lower you set the gain.

X-over = Used to cut the freqs going to a speaker by a set amout. For a sub you want it set on LPF (low pass filter) and at around 80 or below (this is also dependent on the sub). I tend to use a 24db slope, but you can adjust that (most amps offer 12 and 24,) and the x-over point to fit your taste and stereo.

by NViejeP » Wed May 03, 2006 5:39 am

Kicker KX550.3

The knob says Bass Level.

And whil you brought up the gain.. what is gain? What is the xover frequency? I noticed that the shop set it for me.. but when I install my sub on my own, I need to be able to adjust it myself..

by Justin from Detroit1 » Wed May 03, 2006 5:31 am

What kind of amp? Some higher end amps have a remote GAIN know instead of bass, and that is a whole different ballgame there.

by GlassWolf » Tue May 02, 2006 10:58 pm

leave the bass knob at zero/flat.
set the bass on the head unit where you want it, then leave it.
if you want a bit more bass for a song or track, just use the knob from then on and leave the head unit as a reference setting.

by NViejeP » Tue May 02, 2006 10:24 pm

Yah I know. That would work right? Two controls working simultaneously? (Did I spell that right?)

by Robert Wollenberg » Tue May 02, 2006 9:57 pm

I would use the head unit control to balance the system with the other one off, then use the one with the amplifier to pump up the base when you want to. And if you're really trying to blow some stuff up, then crank everything up! lol. Seriously though, that's how I would do it.

Top